B) Cleaning; Handling - Renkforce LV-BH 400 Operating Instructions Manual

Hazer/soap bubble machine
Table of Contents

Advertisement

Available languages

Available languages

b) Cleaning

Disconnect the device from the power supply and leave it to cool down before cleaning.
The device is maintenance-free and you should therefore never open it. If you open it, the guarantee will
expire.
The device can be cleaned with a moist cloth on the outside. Never use aggressive cleaning agents, che-
mical solutions or scouring agents as the paint coating could be damaged.
Wipe the area around the fog and soap bubble exit opening (6) clean after operation. The residue of the
soap bubble fluid may otherwise damage the integrated fan and the housing's coat of paint.
Clean the tank and channels that come into contact with soap bubble fluid by filling water into the tank for
the soap bubble fluid and draining it again through the drain plug TAP (5). For this, put the device up slightly
inclined and place a collection vessel below the drain socket TAP (5).
Avoid deposits and residue in the fog fluid channels by using a special fog machine cleaner. Observe the
instructions for cleaning liquid.

13. Handling

• Never connect the mains plug to a mains socket immediately after the device has been taken from a cold
to a warm environment. The resulting condensation may destroy the device.
Allow the device to reach room temperature before connecting it. Wait until the condensation has eva-
porated.
• Never pull the mains plug from the mains socket by the cable. Only pull it from the mains socket by the
intended grip areas.
• Unplug the mains adapter from the mains socket after use.
• Disconnect the mains plug from the mains socket during thunderstorms for reasons of safety.
• Never touch the device in operation or right afterwards, because this area heats up strongly particularly
in the area of the soap bubble exit opening (6). There is a danger of burns.
• Never use contaminated liquids. Always close the tanks and the storage containers for your fluids imme-
diately after filling.
• Always empty the tanks before transporting the device or if you are not using it for a longer period.
• Use only water-based fog liquids and suitable soap bubble fluids. Suitable fluids are listed on the product
page online under „Accessories".
30

Advertisement

Table of Contents
loading

This manual is also suitable for:

1282018

Table of Contents