OESD Magic Box Instruction Manual page 12

Installation Installation
Software Installation
1. From the Windows desktop close all open programs.
2. Place the Magic Box Program Disk CD in the CD-ROM drive.
Wait a few seconds. If the program begins to install, skip to step 7.
3. From the Windows desktop, click on the Start button.
4. Click on the Run button.
5. At the Run prompt you will need to type the letter of your CD-
ROM Drive followed by Setup. (Ex: D:\SETUP or E:\SETUP.)
You may also press the Browse button and click on the CD-
ROM drive then click on setup.exe fi le. Once the setup.exe fi le
is highlighted press Open. This will copy the command to the
command prompt. Press the Enter key.
6. This will activate the installation.
7. Click Next.
8. Click "I accept"& then click next.
Fig. Inst-1
12
(Fig. Inst-1 Below)
Magic Box - Design Card Converter
(Fig. Inst-2 Below)
Fig. Inst-2
Software Manual