EdilKamin SERBATOIO 250 Installation, Use And Maintenance Manual page 16

OPERATING MODE (USER)
Before the regulator is switched on the display appears as shown in
Switching on the control
To switch on the control, press the P4 button for a few seconds. When the regulator is switched
on the display appears as shown in figura 26.
Language selection
To select the language press the SET button (P3) and "CHOOSE LANGUAGE" will appear.
Press the SET button (P3) again and "MENU 01 - ITA" will appear.
Using the P1 and P2 buttons select the desired language, confirm the selection by pressing P4
twice.
When the sensor detects an insufficient pellet level, the regulator checks the pellet reserve
(pic 27) for 7 seconds; if the level is restored, the pellet present message comes back as in
pic 26, otherwise after 7 seconds pellet loading will start. (see pic 28).
Immediately after this verification, the pellet load phase will be activated for the load time set.
If after the load time expires, the level is restored, the message "PELLETS PRESENT" will
appear, disabling loading; otherwise, and alarm will be signalled and the feed screw motor will
switch off.
Switch-off.
To switch off the feeder, simply press down the 4 button for approx. 2 seconds.
The feed screw will stop immediately and the display will appear as in pic 29.
USE
pic 25.
16
Pic. 25
Pic. 26
Pic.. 27
Pic.. 28
Pic. 29