Verifying Connection To The Router - Airlink101 AR690W User Manual

Blinking: Data transmission
LAN
On (Green): 1000Mbps device is connected
Blinking (Green): Data transmit under 1000Mbps mode
On (Orange): 100Mbps device is connected
Blinking (Orange): Data transmit under 100Mbps mode
WPS (WiFi Protected Setup)
Blinking Blue: WPS set up in progress
Static Blue: WPS set up successfully
Blinking Red: Error found

3. Verifying Connection to the Router

Step 1 Go to Start, Run, type command (for Windows 95/98/ME) or cmd (for Windows
2000/XP) and click OK. You will see the command prompt as below.
Step 2 Type ping 192.168.1.1 and press Enter. You should get four reply responses
back.
Step 3 If you get Request timed out, or Destination host unreachable, double-check
the network cable connection between the computer and the router and try
If you still encounter problem, go to the next step; otherwise proceed to Section 3,
Configuring the Router.
Step 4 For Windows 2000/XP, type ipconfig/release and press Enter. (Windows
98se/ME users skip ahead to Step 6)
6
Step 2 again.