Table of Contents
Advertisement
en | 4 | ATJ-1000H
1. Safety Regulations
1.1 Warnings
The transmission jack was designed only to assist in the
removal and installation of automotive and light truck
transmissions/transfer cases weighing up to 1,000 lbs.
Special factory made adapters are available to help
stabilize some transmissions.
To avoid serious injury or death, read this manual
carefully before operating this unit. Contact the
manufacturer using the contact information on the
back cover of this manual if you have any questions.
Failure to understand and obey safety instructions may
result in unsafe or improper use of this product.
Before using this jack, be sure you have read and
understood all of the instructions and warnings on the
on product labeling and in this owner's manual. See the
section entitled "OWNER AND/OR OPERATOR
RESPONSIBILITIES" on page 6 of this manual for more
information.
Inspect the jack before each use. The jack must be
removed from service if damage is detected or if the
jack is subjected to an abnormal shock or load. See
page 10 of this manual for proper "INSPECTION –
BEFORE EACH USE."
Inspect the work area before each use. Make sure
vehicle is appropriately supported before starting
repairs. Use the jack only on hard, level surfaces
capable of sustaining the load.
Make sure air stage of lift is fully raised or fully
lowered prior to transferring load. If a load is
transferred to the lift when the air cylinder is only
partially raised, the lift will drop suddenly. Do not allow
any part of your body under the load while jack is
supporting a load..
Make sure the load does not exceed the rated
capacity of the jack. The maximum lifting capacity of
the ATJ-1000H is 1,000 lb. /455 kg.
Use the jack only as a lift, not as a workstand. Lift
only by means of the head assembly; never use any
other part of the jack as a lifting surface.
Do not tow loaded jack by hydraulic pump handle.
Keep transmission in the lowest position when rolling
jack across floor. Keep strap tightly secured until ready
to remove transmission from jack.
Do not use this jack to remove and/or install
gas/fuel tanks.
Use only the factory supplied adapters. Do not use
any adapters that are not supplied by
manufacturer.
Always use the jack as intended. Never modify or
alter the jack.
Failure to understand and obey these warnings may
result in personal injury and / or property damage.
Safety Regulations
the
Advertisement
Table of Contents
