Page 1
MAHLE CLS-10 & CLS-15 Operation Manual Truck Air Jack Stand...
Page 2
| 2 | CLS-10/CLS-15 EVERY PERSON WHO OPERATES THIS EQUIPMENT NEEDS TO KNOW AND UNDERSTAND ALL OF THE INFORMATION IN THIS MANUAL – FAILURE TO DO SO COULD RESULT IN SERIOUS INJURY OR DEATH. READ THIS MANUAL CAREFULLY AND...
Safety Regulations en | 4 | CLS-10/CLS-15 1. Safety Regulations Do not exceed the maximum lift height. Never use more than one optional extension adapter with this 1.1 Warnings jack. Failure to follow all of these safety instructions can After lifting the vehicle, never allow any part of your...
Signal words call attention to a safety message or offering of A/C, fluid and nitrogen service equipment, messages, or a property damage message or messages, MAHLE Service Solutions has partnered with Gray and designate a degree or level of hazard seriousness. Manufacturing to provide the highest quality hydraulic...
Responsibilities en | 6 | CLS-10/CLS-15 4. Responsibilities 5. Specifications 4.1 Receiving inspection 5.1 CLS-10 Before attempting to operate this equipment, thoroughly Model CLS-10 US units Metric units read and understand this manual. Completely remove all tape and packaging. Inspect the equipment immediately...
Operation en | 8 | CLS-10/CLS-15 7. Operation 7.2 Preparation before operation WARNING - This section discusses the appropriate and 1. Make sure the vehicle load does not exceed the rated safe methods for using the jack to raise and lower a capacity of the jack (see Specifications for the jack vehicle.
Operation CLS-10/CLS-15 | 9 | en 7.3 Identify a lift point on the vehicle and 7.5 Support the vehicle. position the jack 1. Make sure the vehicle is stable. If using two units, 1. Identify a lift point on the vehicle that is capable of make sure the vehicle is level.
Maintenance and Inspection en | 10 | CLS-10/CLS-15 8. Maintenance and Inspection 8.2 Maintenance instructions WARNING - The jack must be inspected according to WARNING - All inspection and maintenance procedures the requirements of this section. Failure to properly must be performed after the jack has been removed from inspect the jack could lead to severe injury or death.
Troubleshooting CLS-10/CLS-15 | 11 | en 9. Troubleshooting This section is a list of potential problems and solutions. If the solution listed fails to correct the problem, call the manufacturer at the numbers and address printed on the back cover of this manual. Please have the model number, and serial number of your jack available.