Subscribe to Our Youtube Channel
Related Manuals for WINTACT WT63A
Summary of Contents for WINTACT WT63A
- Page 1 MODEL：WT63A Vibration Meter User's Manual Version：WT63A-0 71680631004 WT63A 英文有唛说明书 材料:105G双铜; 成品尺寸:190*130MM; 公差:+-1.0MM;页数：20P;工艺:单色双面印刷,加工:骑马钉...
-
Page 2: Table Of Contents
1. Before use Contents Check-up 1. Before use Carefully unpack your kit and ensure that you have Check-up---------------------------------------------(01) the following items. In case that any item is missing or Introduction------------------------------------------(02) if you find any mismatch or damage, promptly contact Features ---------------------------------------------(02) your dealer. -
Page 3: Introduction
Specifications Introduction This product adopts piezoelectric effect of artificial po- Technical parameter Technical specification Vibration pickup Piezoelectric ceramic accelerometer (shear-type) larized ceramic for design. It is suitable for monitoring Measurement range 0.1~199.9m/s peak all kinds of vibrating mechanical facility, specially the of acceleration vibration measurement of rotating and reciprocating Measurement range... -
Page 4: Diagram Of The Product
LCD Display Diagram of the product mm/s Backlight indication, the backlight will be activ- ed for 7 seconds upon the button operations. Measurement data High frequency 1KHZ frequency 1). LCD screen Low frequency Battery mark shows battery 2). Probe power. Has following 5 levels: Frequency selection key (only in acceleration LO/HI :battery is sufficient... -
Page 5: Operation
2. Operation Battery Installment Select Probe tip a. Grip tightly the unit body with your left hand; hold down the battery door with your right hand thumb to open it Probe tip is used as following 3 conditions, please according to the arrow referring direction, as shown in probe according to actual condition: following figure: a. -
Page 6: Turn On The Unit And Check-Up Battery
Select Measurement Mode Turn On The Unit And Check-up Battery a. Press the key to select measurement mode, the A/V/D a. Press the MEAS key to turn on the unit, as shown in default mode is acceleration mode, as shown in following figure: following figure: b. -
Page 7: Select High/Low Frequency
Measurement Select High/low Frequency:( High frequency is only for acceleration measurement mode) As per the to-be-measured and frequency of vibration structure, select corresponding measurement mode A. press the key to select high frequency (HI) or low LO/HI (Acceleration/ Velocity/ Displacement) and frequency frequency (LO) , as shown in following figure: (HI/LO frequency). -
Page 8: Vibration Conversion Chart
Vibration conversion chart Displacement measurement 10000 5000 b. When the MEAS key is pressed again, the current value 3000 will be canceled, and a new measurement can be 2000 preformed. 1000 Note: a. Using short Probe (S) can take measurement of vibration both in high(HI) and low(LO) frequency. -
Page 9: Contact Resonance In Acceleration Measurement
Contact resonance in acceleration measurement: (worked with FFT signal analyzer) Without Accessory Without Accessory Accessory S Accessory Accessory L Accessory Frequency(Hz) Frequency(Hz) HI range LO range -14- -15-... -
Page 10: Other Items
3.Other items Maintenance Attentions 1. Replacement and upkeep of battery: a. After power on, if an icon appears on the LCD, you need to replace the battery immediately, for details Warning please refer figures and contents on page 9 of this When making measurements on exposed rotating manual.
Need help?
Do you have a question about the WT63A and is the answer not in the manual?
Questions and answers