Hints And Tips; Cleaning And Maintenance - Morphy Richards 47508 Manual

47507 rev2 29/6/06 14:14

HINTS AND TIPS

Cleaning and
maintenance
You must clean the steam
nozzle and froth attachment
immediately after each use.
1 1 Simply wipe the steam nozzle,
warming plate and exterior with
a clean, damp cloth. Do not use
any abrasives or metal scourers
as this will damage the finish on
the unit.
Briefly push the lever to the
steam setting to clear any
remaining milk out of the steam
nozzle.
W W A A R R N N I I N N G G : : S S t t e e a a m m f f r r o o m m t t h h e e
n n o o z z z z l l e e i i s s e e x x t t r r e e m m e e l l y y h h o o t t a a n n d d
c c a a n n s s c c a a l l d d . .
2 2
Place the froth attachment
under warm running water to
remove excess milk.
IMPORTANT: Never wash your
coffee machine accessories in a
dishwasher.
3 3 The filters, filter holder and
water reservoir should be
washed after each use by
rinsing them under water. To
assist in keeping the filters
clean we recommend you
periodically run the machine
with the filter in place, without
coffee, using water only.
Should the holes in the filters
become blocked with coffee
granules use a fine bristled
brush.
When your coffee maker is not
being used, we recommend
that you do not leave the filter
holder attached to the machine
as this will reduce the life of the
gasket.
Descaling
• If you live in a harder water
area, we recommend that your
coffee maker is descaled at
regular intervals, eg. every 2 - 3
months. In areas of moderately
hard water you should descale
every 6 months.
9 9
Page 9
• If the water filters through more
slowly than usual, it is a sign
that descaling is necessary.
• We recommend you to use
proprietary liquid descaler
which is especially made for
coffee makers and plastic
kettles. Follow the instructions
on the bottle or sachet, and
then operate the coffee maker
with just water 3 times before
making coffee.
• Do not use kettle descaler
unless the packet specially
states it is suitable for coffee
makers.
Drip tray
The water level indicator ·
1 1
appears through the grid to
indicate that the drip tray is full.
2 2
Remove the grid of the drip tray
by placing fingers in the two
holes in the centre of the drip
tray and lift off. S This must be
done regularly or as soon as the
red water level indicator
appears through the grid.
3 3
Lift the front of the drip tray up
and slide it out. T
4 4 Lift off the plastic lining of the
drip tray. U Clean the drip tray
and its grid with water and a
little washing up liquid, rinse
and dry.
5 5 Reverse the procedure to
reassemble.
Note: Ensure that when you are
replacing the drip tray that the
plastic lining is in the correct
position.
w w w w w w . . m m o o r r p p h h y y r r i i c c h h a a r r d d s s . . c c o o m m
w w w w w w . . m m o o r r p p h h y y r r i i c c h h a a r r d d s s . . c c o o m m
S
T
U
8 8 9 9