Usb Devices - Adaptec 2126900-R Manual

C
ONNECTING
You can connect standard USB 1.1 or high-speed USB 2.0 devices
to the USB2connect's external or internal connectors. A 10-foot
(3-meter) USB 2.0 certified high-speed cable is included. This
cable plugs into the connectors on the USB2connect card.
N
OTE
•
•
•
•
The USB2connect 5100 adapter shares one internal and external
connector so that only five can be used at once. The default
setting is that all five external connectors are enabled, and the
internal connector is disabled. To enable the internal port, set the
jumpers. See the figures below:
External Port Enabled (default)
Internal Port Enabled
USB D
EVICES
The USB2connect supports hot-plugging, allowing USB
devices to be attached and recognized even when the com-
puter is powered
Some peripheral manufacturers support hot-plugging in
different ways. See instructions for each device to deter-
mine the best way to attach and mount the peripheral.
Check http://www.
ability. USB 2.0 drivers are not included.
USB 1.1 devices runs at USB 1.1 speeds even when con-
nected to USB 2.0 host adapters or hubs. USB 2.0 devices
operate at USB 1.1 speeds when connected to USB 1.1 host
adapters or hubs.
.
ON
for the latest driver avail-
adaptec.com
All 5
external
ports
enabled
disabled
These 4
ports
enabled
5
jumpers
disabled
jumpers
enabled