Troubleshooting - Fieldmann FDEB 200451-E User Manual

6. TROUBLESHOOTING

Suspected malfunctions are often due to causes the user can fi x themselves. Therefore check the product using
this section .In most cases the problem can be solved quickly.
WARNING!
Only perform the steps described within these instruction s! All further inspection,
maintenance and repair work must be performed by an authorized service centre or
a similarly qualifi ed specialist if you cannot solve the problem yourself !
Problem
1. Product does not start
2. Product does not reach full
power
3. Unsatisfactor y result
4. Excessive vibration or noise
ELECTRICAL ORBITAL SANDER
Possible Cause
1. 1 Not connected to power supply 1. 1 Connect to power supply
1.2 Power cord or plug is defective 1.2 Check by a specialist
1.3 Other electrical defect to the
product
2. 1 Extension cord is not suitable
for opera tion with this product.
2.2 Power source (e.g. generator)
has too low voltage
2.3 Air vents are blocked
3. 1 Disk bit is dull/damaged
3.2 Disk bit is not suitable for work
piece material
4. 1 Disk bit is dull/damaged
4.2 Bolts/nuts are loose
Troubleshooting
Solution
electrician
1.3 Check by a specialist
electrician
2. 1 Use a proper extension cord
2.2 Connect to another power
source
2.3 Clean the air vents
3. 1 Replace with new one
3.2 Use proper drill bit
4. 1 Replace with a new one
4.2 Tighten bolts/nuts
USER'S MANUAL
13 EN