Advertisement
Step 3. Operate garage door by hand.
Step 4. Reconnection of the automatic operator.
Once the manual release rod is removed completely, you will
be able to lift or close the garage door manually by hand.
When operating the garage door manually at anytime or in
any location through the fully open to fully closed locations,
check the surrounding areas each side, behind and in front
of the garage door to ensure no obstructions may foul the
door operation.
All counterweight garage doors are inherently heavy, it is
advised that when using any garage door by hand the
operator should remain diligent when operating the door to
ensure it does not open or close unexpected.
To reconnect the automatic operator to the garage door, manually
operate the garage door by hand until the automatic operator
carriage lines-up with the steel ramp rails.
Once in-line, re-insert the manual release rod into the automatic
operator point by turning the release rod clockwise.
Continue to turn the release rod clockwise until the steel bearing
on the release rod is located between the steel ramp plates.
PDS Garage Doors & Gates
38 Yale Drive
Epping (Vic) 3076
Phone: (03) 9408 3418
Email: service@pdsgaragedoors.com.au
Web: www.pdsgaragedoors.com.au
Advertisement
