Important Information - Gazer F230w User Manual

EN
•
Do not insert or remove the SD card when the device is on
or working from the battery. This can lead to the dash cam
malfunction. Before removing the memory card, make sure that
the power and all dash cam indicators are off.
•
Make sure to set the correct time and date before using the
device.
•
Use at least 0.5 seconds time interval between pressing control
buttons, this guarantees proper functioning of the device.
•
Be careful when connecting the power cable to the device. Do
not confuse the dash cam power cable and the radar detector or
GPS unit power cables, which may have a voltage of +12 V. The
device may get damaged if connected using such cables.
•
Do not turn off the power for at least 20 seconds after the power
supply cable is connected. This is necessary to help the built-
in battery function correctly. If after you have started the car
(when the power supply cable is connected to the dash cam),
the device failed to switch to the recording mode automatically,
simply unplug the power cable for ten seconds and then try
again.
•
Use the restart option (by pressing RESET button) in the
following cases:
• power indicator is not on when the power cable is connected;
• the device does not switch from the standby to the recording
or control mode;
• the device fails to function properl.
•
Files protected from overwriting by G-sensor or by pressing a
corresponding button are recorded in a loop with a 30% limit
of amount on the memory card. Check the free space left on
your memory card on a regular basis to prevent data loss (this
happens when the memory card is full).
6

Important information

Warning!