Download Print this page

Check The Scsi Ids; Terminate The Ends - Adaptec 29160N Installation Manual

Scsi card pci-ultra 160 scsi controller
Hide thumbs Also See for 29160N:

Advertisement

512512final.qxd
12/17/99 2:05 PM
Page 5

Check the SCSI IDs

The Adaptec SCSI Card 29160N and each device you connect to it
must have a unique SCSI ID number ranging from 0 to 15.
No two devices can have the same number.
The Adaptec SCSI Card 29160N is preset to ID 7 and should not be
changed. If you boot from a SCSI hard disk, make sure the hard disk
SCSI ID is set to 0 or 1. Most SCSI hard disks come from the factory
preset to ID 0. The IDs for internal devices are usually set with jumpers;
external devices are usually set with a switch on the back of the device.

Terminate the Ends

To ensure reliable communication on the SCSI bus, the device at the
end of each cable, or the end of the cable itself, must have a terminator
installed (or enabled). Terminators must be removed, or termination
must be disabled, on devices between the ends of each cable.
5

Advertisement

loading