Variable height arm with slide-in mounting plate (17 pages)
Summary of Contents for GCX Kaiser NFS
Page 1
Installation Guide Kaiser NFS Health Connect Roll Stand Kit (Spec.# CROC202) The purpose of this guide is to describe procedures for mounting equipment on roll stand. Parts Reference The following parts and hardware are included in this installation kit (hardware not shown):...
Page 2
Remove plastic bolt cap. Using a 1/2'' wrench, tighten or loosen tension adjustment nut (above right). Adjusting Tilt Tension Using the 5/32'' hex key provided, equally loosen or Tilt Tension Screws tighten two (2) socket head cap screws on top of the Tilt Clamp (right). DU-KP-0002-61 Rev D 3/23/06 GCX Corp. Page 2 of 4...
Page 3
Mouse Tray before initial use. 3. A mouse cradle is provided for storing mouse when not in use. Typical location shown below right. Cable Retainers (2) Mouse Cradle Mouse Trays (2) Nylon Screws (2) DU-KP-0002-61 Rev D 3/23/06 GCX Corp. Page 3 of 4...
Page 4
Installation Note: Typical installation using cable management supplies is shown in photos below. Post Clips (2) Poly Cord Wrap (Use 2' length for upper cables and 3' length for lower cables) Nylon Cable Ties (2) Post Clips (2) Gray Poly Conduit DU-KP-0002-61 Rev D 3/23/06 GCX Corp. Page 4 of 4...