Connecting The Camera - D-Link DCS-6517 Quick Installation Manual

Place the rubber seal between the right-angle
bracket and the ceiling to ensure a waterproof seal
between the ceiling and the bracket.
Attach the right-angle bracket to the ceiling using
the screws provided.
Attach the bracket cap to the bottom of the right-
angle bracket by rotating the cap counterclockwise
to tighten it into place.
Insert the screw into the base of the right-angle
bracket at the top of the bracket cap to secure the
bracket cap into place.
Thread an Ethernet cable and the power cable
through the pendant bracket.
Place the camera body onto the bracket cap and
attach the dome to the base of the camera using
the three long screws and the security screw.
Connection with a PoE Switch
Connect the Ethernet cable to your PoE
•
switch or injector. The Ethernet cable will
provide the camera with both power and a
network connection.
If you have the optional cable harness, you can
also use the following connection method:
General Connection Using 12 V DC Power
Adapter (not included)
Connect the Ethernet cable to your network.
•
Connect your power adapter to the camera's
•
power connector, then plug in the power
adapter.

Connecting the Camera

D-Link DCS-6517 Quick Installation Guide