Assembly - Remington HH-400T-KFA User's Manual & Operating Instructions

NEVER LEAVE HEATER
UNATTENDED WHILE BURN-
ING OR WHILE CONNECTED
TO A POWER SOURCE

Assembly

Model
Wheel Support Frame
Wheels and Axle
Wheel Caps
Front Handle
Rear Handle
Cord Wraps
Screws, Nuts and Washers
TOOLS REQUIRED
• MEDIUM PHILLIPS SCREWDRIVER
• OPEN OR ADJUSTABLE WRENCH, USE US (INCH) SCREWS
NUTS
• LONG NOSE PLIERS
ASSEMBLING WHEEL & HANDLE
1. Slide axle through wheel support frame. Install wheel bushings,
flat washers (S) and wheel on axle.
NOTE: When installing wheels, tube valve should face out from
support frame (Figure 5).
©2014 Pinnacle Products International, Inc. Kerosene Heater User's Manual
HH-400T-KFA
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Wheels
(Pneumatic)
Wheel Caps
(Black Rubber)
Front Handle
Wheel Support Frame
Figure 3. Component Identification
Flat Washers (S)
Screws (L)
Screws (S) Cotter Pins
Cord Wraps
Nuts
Axle
2. Place flat washers (L) and cotter pins on axle ends and bend
cotter pins with long nose pliers to secure.
3. Place wheel cap on flat washers (L) and put wheel cap in flat
washers (L) end.
4. Place heater on wheel support frame. Make sure air inlet end
(rear) of heater is over wheels. Align the holes on fuel tank
flange. Insert screws through handles (front and rear), fuel tank
flange, and wheel support frame as shown in Figure 5 and
attach nut finger tight after each screw is inserted.
5. After all screws are inserted, tighten nuts firmly.
Do not operate heater without support
CAUTION
frame fully assembled to tank.
Kerosene
Forced Air Heaters
Flat Washers (L)
Bushings
Rear Handle
Page 5