Table of Contents
Advertisement
Quick Links
Cat. No. / No de cat.
6141-30, 6141-31, 6142-30, 6142-31
4-1/2" GRINDERS
RECTIFIEUSES 115 mm (4-1/2")
ESMERILADORAS DE 115 mm (4-1/2")
WARNING
AVERTISSEMENT
comprendre le manuel.
ADVERTENCIA
To reduce the risk of injury, user must read and understand operator's manual.
Afin de réduire le risque de blessures, l'utilisateur doit lire et bien
Para reducir el riesgo de lesiones, el usuario debe leer y entender el manual.
OPERATOR'S MANUAL
MANUEL de L'UTILISATEUR
MANUAL del OPERADOR
Advertisement
Table of Contents
Related Manuals for Milwaukee 6141-30
Summary of Contents for Milwaukee 6141-30
- Page 1 OPERATOR'S MANUAL MANUEL de L'UTILISATEUR MANUAL del OPERADOR Cat. No. / No de cat. 6141-30, 6141-31, 6142-30, 6142-31 4-1/2" GRINDERS RECTIFIEUSES 115 mm (4-1/2") ESMERILADORAS DE 115 mm (4-1/2") WARNING To reduce the risk of injury, user must read and understand operator's manual.
-
Page 2: Electrical Safety
GENERAL POWER TOOL • Do not overreach. Keep proper footing and bal- ance at all times. This enables better control of the SAFETY WARNINGS power tool in unexpected situations. Read all safety warnings, instruc- WARNING • Dress properly. Do not wear loose clothing or tions, illustrations and specifica- jewelry. - Page 3 • Do not operate the power tool near flammable • Operations such as polishing are not recom- materials. Sparks could ignite these materials. mended to be performed with this power tool. • Do not use accessories that require liquid cool- Operations for which the power tool was not designed ants.
-
Page 4: Specifications
Rated Revolutions per Minute (RPM) • Maintain labels and nameplates. These carry im- portant information. If unreadable or missing, contact UL Listing Mark for Canada and U.S. a MILWAUKEE service facility for a free replacement. • Some dust created by power sanding, WARNING... -
Page 5: Extension Cords
• Protect your extension cords from sharp objects, cord or plug is damaged. If damaged, have it excessive heat and damp or wet areas. repaired by a MILWAUKEE service facility before Recommended Minimum Wire Gauge use. If the plug will not fit the outlet, have a For Extension Cords* proper outlet installed by a qualified electrician. - Page 6 3. Wipe the flange, flange nut and spindle to remove dust and debris. Inspect the parts for damage. Re- To reduce the risk of injury, always WARNING place if needed. Use only MILWAUKEE mounting use a side handle when using this hardware designed for your tool. tool. Hold securely.
-
Page 7: Operation
To stop the tool, squeeze and release the paddle switch. Make sure age. Replace if needed. Use only MILWAUKEE mounting hardware designed for your tool. the tool comes to a complete stop before laying the 3. -
Page 8: Troubleshooting
Using Cut-Off Wheels Control pressure and surface contact between wheel and workpiece. Too much pressure causes Cut-Off Wheels are suited for small cut-off and shal- over-bending of wires and heat build-up causing low notching operations only. premature wire breaking, rapid dulling and reduced The guard type must match the WARNING brush life. -
Page 9: Maintenance
MILWAUKEE’s website www.milwaukeetool.com or call 1.800. Support with technical, service/repair, or warranty SAWDUST (1.800.729.3878) to locate your nearest service facility for warranty and non-warranty service on a Milwaukee electric power tool . questions. LIMITED WARRANTY - MEXICO, Email: metproductsupport@milwaukeetool.com CENTRAL AMERICA &...