Super Io Device Configuration; Hardware Health Monitor - Acer AR160 F1 Series User Manual

Load Onboard LAN1 Option ROM/Load Onboard LAN2 Option ROM:
Select Enabled to enable the onboard LAN1 or LAN2 Option ROM. This
is to boot computer using a network interface.
Onboard LAN Option ROM Select: Select iSCSI to use the iSCSI Option
ROM to boot the computing using a network device. Select PXE to use
the PXE Option ROM to boot the computer using a network device.
Boots Graphic Adapter Boot Priority: This feature allows you to select
the graphics adapter to be used as the primary boot device.

Super IO Device configuration

Serial Port1 Address/ Serial Port2 Address: This option specifies the
base I/O port address and the Interrupt Request address of Serial Port 1
and Serial Port 2. Select Disabled to prevent the serial port from
accessing any system resources. When this option is set to Disabled, the
serial port physically becomes unavailable. Select 3F8/IRQ4 to allow the
serial port to use 3F8 as its I/O port address and IRQ 4 for the interrupt
address.
Serial Port 2 Attribute: Select COM to configure the onboard COM2
port as a normal serial port. Select SOL (Serial Over_LAN) to configure
the onboard COM2 port as a virtual COM port for SOL use.

Hardware Health Monitor

This feature allows you to monitor system health and review the status
of each item as displayed.
CPU Overheat Alarm: This option allows you to select the CPU
Overheat Alarm setting which determines when the CPU OH alarm will
be activated to provide warning of possible CPU overheat.
Warning: Any temperature that exceeds the CPU threshold
temperature predefined by the CPU manufacturer may result in
CPU overheat or system instability. When the CPU temperature
reaches this predefined threshold, the CPU and system cooling
fans will run at full speed.
The options are:
• The Early Alarm - Select this setting if you want the CPU overheat
alarm (including the LED and the buzzer) to be triggered as soon
71