Table Of Contents - STACKER S Series User Manual

Table of Contents

1. Warnings
2. Introduction
2.1 Product Registration
2.2. Software
2.3. Printer Specifications
3. Unboxing
3.1. Hardware List
3.2. Final Printer Assembly
3.3. Uninterruptible Power Supply (UPS)
4. Your First Print
5. Changing Nozzles and Filament Guide Tube
5.1 Changing Nozzles
5.2 Changing Filament Guide Tubes
6. Printer Calibration
6.1 Adjusting First Layer Height
6.2 Stacker Run
6.3 Volumetric Calibration
6.4 S2 and S4 Bed Leveling
6.5 S4XL Bed Leveling
6.6 Leveling Nozzles
7. Filament Out Switch
8. Basic Printer Maintenance
8.1 Keep Your Printer Clean
8.2 Linear Guide Rails
8.3 Filament Drive Gears
8.4 Filament Guide Tubes
9. Terms and Conditions
Page 2