Installation; Tm Dimensions - Magnum Energy ME-SBC Owner's Manual

Installation

2.0 Installation
Before installing the ME-SBC
pects of the installation; then you can thoroughly plan the details to ensure
the overall system requirements are accomplished.
To assist you in planning and designing your installation; you should review
the basic system diagram shown in Figure 2-2 and Figure 2-3.
Info: Installations should be performed by qualifi ed personnel, such
as a licensed or certifi ed electrician. It is the installer's responsibility
to determine which safety codes apply and to ensure that all ap-
plicable installation requirements are followed.
Info: Review the "Important Product Safety Information" on the
front inside cover page before any installation.
2.2 Location and Mounting
Select a location that is dry and away from extreme temperatures to mount
the ME-SBC ; using the supplied #8 x 3/4 screws (x4). Allow ample room to
TM
access the three adjustment dials, to view the LEDs and to access the terminal
blocks; refer to Figure 2-1 for dimensions on the ME-SBC
CAUTION: Do not mount the ME-SBC
ment or in an area
ME-SBC and cause shorting or corrosion. The internal circuit board
TM
is conformal coated to help prevent corrosion. However, a failure that
is caused by corrosion is not covered by the warranty.
WARNING: This device is not tested for Ignition Protection. Do not
install this device in a gasoline engine room or any other area that
requires an ignition protection rating.
4.2"
1.4"
Figure 2-1, ME-SBC
3
, read this entire section to be aware of all as-
TM
where water
4.9"
4.2"
5.4"
Dimensions
TM
.
TM
in a closed battery compart-
TM
or any other liquid can enter the
2.0"
©2009 Magnum Energy Inc.