Table of Contents
Advertisement
Repeated
dishwasher
Defective PCB assembly
cycles.
Water remains
A small amount of water (in sump area) is
in bottom
normal.
Defective drain pump
Defective Check plate
Defective One way valve
Spotting or
Detergent allowed to stand too long in the
filming on
dispenser
glasses
detergent are being used.
(reposition of
food soil).
Improper loading of dishes, pots,
pans, and nesting of silverware.
Noisy pump
Debris in bottom of tub sump area.
assembly.
Pump parts were not properly installed.
Impellers are not properly shimmed or are
rubbing.
Poor
Clogged filter assembly.
washability.
Dishware stop the sprayer
Improper loading of dishes, pots, pans,
and nesting of silverware.
Little detergent/rinse module
Select improper program
Defective detergent/rinse module
Defective spray arm.
Too little water fill.
Defective motor pump
Poor drying of
Improper loading of dishes, pots, pans,
dishes
and nesting of silverware.
Select improper program
Defective dispenser
Too much water fill.
Water leaks
Defective tub seal.
from
Defective softener gasket.
dishwasher.
Defective drain pump
Dishwasher not level.
Soap suds leak from dishwasher.
Loose hose clamps.
Loose heater element.
Defective sump seals.
Motor and drain pump assembly not
seated properly with sump.
Defective
assembly seals.
or
excessive
amounts
Heater
elements
Replace the PCB assembly
This is necessary to keep the pump primed and is
drained automatically at the beginning of each
cycle.
Replace the drain pump.
Clean or Replace the Check plate
Clean or Replace the One way valve
of
Instruct the customer on proper use of dishwasher
detergent. Refer to the
owner's manual.
Clean out the sump area.
Inspect the pump and correct and installation
errors.
Use the shim guage furnished in the impeller seal
kit. When the seal is properly shimmed the
impellers will be in the correct operating position.
Clean the filter assembly.
revolve the sprayer before wash.
Refer to the owners manual.
Replace the etergent/rinse module.
Check spray arm for proper rotation.
See "Too little water fill" symptom.
Replace the motor pump
Instruct the customer on proper loading of the
dishwasher. Refer to the owners manual.
Replace the dispenser
See previous symptom.
Replace the tub seal.
Replace softener gasket.
Replace the drain pump
Level the dishwasher.
Refer to use and care manual.
Tighten or replace hose clamps.
Tighten heater element mounting nuts.
Replace the sump seals.
Remount the motor and drain pump assembly.
support
Remount Heater elements support assembly.
23
Advertisement
Table of Contents
