Table Of Figures - DYNACO PAT-5 Assembly Manual

Table of Figures

Figure 1-Assembled PAT-5 Power Supply......................................................................... 6
Figure 2-Empty the power supply components into a soup bowl ....................................... 7
Figure 3-Silk screen shows power supply component locations ........................................ 7
Figure 4-Applying thermal compound ................................................................................ 9
Figure 5-Regulator and Heat Sink mounting screws and soldering mounting posts ........ 10
Figure 6-Assembled Power Supply .................................................................................. 10
Figure 7-Remove hardware that holds power supply bracket to chassis floor ................. 11
Figure 8-Remove these 2 screws and 2 screws on the opposite side ................................ 12
Figure 9-Remove the screws and nuts that hold the zig-zag shield to back and front of
chassis ............................................................................................................................... 12
Figure 10-Original Transformer wiring ............................................................................ 13
Figure 11-Mount new PCB to shield and mounting brackets ........................................... 17
Figure 12-wiring power from back to front with jumpers ................................................ 19
Figure 13-Separate runs for power to phono stages and line stages ................................. 19
Figure 14-Schematic of Power Supply ............................................................................. 21
Page 3 of 21