Pioneer AVIC-Z820DAB Operation Manual page 128

Menu Item
[Firmware Update]
[3D Calibration Status]
Description
CAUTION
• The external storage device for updating must contain only the
correct update file.
• Never turn this product off, eject the SD memory card or
disconnect the USB storage device while the firmware is being
updated.
• You can only update the firmware when the vehicle is stopped
and the handbrake is engaged.
• You cannot update the old firmware version once the latest
firmware is updated.
Download the firmware update files into your
1
computer.
Connect a blank (formatted) storage device to your
2
computer then locate the correct update file and copy
it onto the USB storage device.
3 Set the external storage device to this product
(page 89).
Turn the source off (page 72).
4
5 Display the [System] setting screen (page 119).
Touch [System Information].
6
Touch [Firmware Update].
7
8 Touch [Continue].
Follow the on-screen instructions to finish updating the
firmware.
NOTE
If an error message appears on the screen, touch the display and
perform the above steps again.
Check the sensor learning status, such as the degree of
learning. You can also check the current sensor values and
the total number of speed pulses.
To delete the learned results stored in the sensor, follow
the below instructions.
1 Touch [Distance] or [Speed Pulse], and then touch
[Yes].
Touch [Learning] and then touch [Reset All].
2
TIP
Touch [Reset All] to reset the sensor after changing the
installation position or angle.
NOTE
If you touch [Reset Distance], all learned results stored in
[Distance] are cleared.
- 128 -