Menu Item
[Ground]
[Parking Assist Guide]
[On] [Off]
[Parking Assist Guide
Adjust]*
* This setting is available only when you stop your vehicle in a safe place and apply the handbrake.
Description
The polarity of the connected lead is negative.
NOTE
If the camera polarity setting is wrong, or wrong camera setting is
made, press and hold
and then change the camera polarity setting to [Battery].
You can set whether to display the parking assist
guidelines on the rear view camera images when backing
up your vehicle.
Adjusting the guidelines by dragging or touching
/ /
/
on the screen.
Touch [Default] to reset the settings.
CAUTION
• When adjusting the guidelines, be sure to park the vehicle in a
safe place and apply the handbrake.
• Before getting out of the car to place the markings, be sure to
turn the ignition switch off (ACC OFF).
• The range projected by the rear view camera is limited. Also, the
vehicle width and distance guidelines displayed on the rear view
camera image may differ from the actual vehicle width and
distance. (The guidelines are straight lines.)
• The image quality may deteriorate depending on the usage
environment, such as at night or in dark surroundings.
NOTE
Using packing tape or similar tape place markings as shown below
before setting up the guidelines so that the guidelines can be
overlaid to the markings.
2 m
Markings
Markings
- 122 -
to release the rear view camera screen
50 cm
25 cm
25 cm
Rear bumper
/ /