Removing/Assembling Drawers; Removing/Assembling The Vent Trim - LG LSES6338 Owner's Manual

62 MAINTENANCE
Hinge arm
a
Hinge lock
b
5
Close the oven door.

Removing/Assembling Drawers

Removing Drawers
CAUTION
• Disconnect the electrical power to the range at
the main fuse or circuit breaker panel. Failure to
do so can result in severe personal injury, death,
or electrical shock.
Most cleaning can be done with the drawer in
place; however, the drawer may be removed if
further cleaning is needed. Use warm water to
thoroughly clean.
1
Fully open the drawer.
2
Unscrew the screw
drawer.
3
Locate the glide lever on each side of the
drawer. Push down on the left glide lever and
pull up on the right glide lever.
on the back of the
a
Lever
a
Push down with finger
b
Pull up with finger
c
4
Pull the drawer away from the range.
Assembling Drawers
1
Pull the bearing glides to the front of the
chassis glide.
2
Align the glide on each side of the drawer with
the glide slots on the range.
3
Push the drawer into the range until levers
click (approximately 2 inches).
4
Screw the screws on the back of the drawer.
5
Pull the drawer open again to seat the
bearing glides into position.
Removing/Assembling the Vent
Trim
Removing the Vent Trim
1
Using a screwdriver, remove the 3 screws
holding the vent trim in place.