2.2 Connecting the Monitor and Stand
Align the stand's four tabs with the slots on the bottom of the monitor.
Insert the tabs into the slots.
Slide the stand towards the front of the monitor.
NOTE: Special protection on control knobs and LED indicator needs to be taken care while you place the CRT
side of side of monitor downwards. Such concern will escape the permanent damage occurred on
encoder and LED lens from excessive pressure.
2.3 Choosing A Workstation
When choosing an appropriate workspace, keep these few things in mind:
A sturdy, level surface.
An electrical wall outlet and a telephone wall jack near the computer.
At least 3-inch clearance at the back of the computer to allow for the required airflow.
Do not place near a window. Exposing the Monitor to direct sunlight for extended periods may
damage the unit.
You may want to use a desk lamp to adjust the ambient lighting for your viewing comfort.
A viewing filter is recommended to reduce eye stress and fatigue.
Figure 1: Monitor and Stand Connection
Figure 2: The Workstation (This bevel is representative)
4