Removing the Hard Diskette Drive and Floppy Diskette Drive
1.
See "Removing the Housing Cover" on page 86
2.
See "Removing a Dummy Link Bar" on page 87
3.
See "Removing a Link Bar" on page 87
4.
Turn the link bar over, and then detach the hard disk drive power connector and hard disk drive IDE cable
from the hard disk drive
.
5.
Detach the floppy disk drive power connector and floppy disk drive cable from the floppy disk drive.
6.
Detach the floppy disk drive cable and hard disk drive IDE cable from the main board.
7.
Remove the four screws as shown here and then detach the hard disk drive module from the link bar.
.
Chapter 3
92