Removing The Main Board; Removing The I/O Port Bracket - Acer Veriton 5500 Service Manual

Removing the Main Board

1. See "Removing the Housing" on page 99. (Remove the left panel only)
2. Put the housing to lying position with the open area facing upward.
3. See "Removing the AGP VGA Card" on page 100
4. See "Removing the Modem Card" on page 100
5. Before you remove the system main board, make sure that all cables connected to the main board are
removed.
6. Remove the eight screws holding the main board and then remove the main board from the housing.

Removing the I/O Port Bracket

1. See "Removing the Housing" on page 99. (Remove the left panel only)
2. Put the housing to lying position with the open area facing upward.
3. See "Removing the AGP VGA Card" on page 100
4. See "Removing the Modem Card" on page 100
5. See "Removing the Main Board" on page 108
6. Slide the bracket and then lift it up in the direction as shown
.
Chapter 3 108