Table of Contents
Advertisement
G2E146-BF01-35
3.2 Nominal data
Motor
M2E068-EC
Phase
1~
Nominal voltage / VAC
230
Frequency / Hz
60
Method of obtaining
fa
data
Valid for approval/
-
standard
-1
Speed (rpm) / min
2650
Power consumption / W
285
Current draw / A
1.25
Capacitor / µF
5
Capacitor voltage / VDB
400
Capacitor standard
S0 (CE)
Min. back pressure / Pa
250
Min. ambient
-25
temperature / °C
Max. ambient
30
temperature / °C
ml = Max. load · me = Max. efficiency · fa = Free air
cs = Customer specification · ce = Customer equipment
Subject to change
3.3 Technical description
Weight
3.85 kg
Size
146 mm
Motor size
68
Rotor surface
Unpainted
Impeller material
Sheet steel, galvanized
Housing material
Die-cast aluminum
Direction of rotation
Clockwise, viewed toward rotor
Degree of protection
IP44
Insulation class
"B"
Moisture (F) /
H0 - dry environment
Environmental (H)
protection class
Installation position
Any
Condensation
None
drainage holes
Mode
S1
Motor bearing
Ball bearing
Touch current
< 0.75 mA
according to IEC
60990 (measuring
circuit Fig. 4, TN
system)
Motor protection
Thermal overload protector (TOP)
internally connected
Protection class
I (with customer connection of protective
earth)
Comment on CE
Commissioning not permitted in the
European Economic Area
Approval
CSA C22.2 No. 113; CCC; UL 1004-3;
EAC
Item no. 10454-5-9970 · ENU · Change 226420 · Approved 2021-03-23 · Page 5 / 11
ebm-papst Mulfingen GmbH & Co. KG · Bachmühle 2 · D-74673 Mulfingen · Phone +49 (0) 7938 81-0 · Fax +49 (0) 7938 81-110 · info1@de.ebmpapst.com · www.ebmpapst.com
Operating instructions
1~
; Use the device in accordance with its degree of protection.
230
60
Information on surface quality
The surfaces of the products conform to the generally applicable industrial
fa
standard. The surface quality may change during the production period.
This has no effect on strength, dimensional stability and dimensional
UL 2111
accuracy.
The color pigments in the paints used perceptibly react to UV light over
2650
the course of time. This does not however in any way affect the
295
technical properties of the products. The product is to be protected against
1.65
UV radiation to prevent the formation of patches and fading. Changes in
5
color are not a reason for complaint and are not covered by the warranty.
400
UL
3.4 Mounting data
250
Any further mounting data required can be taken from the product
-25
drawing or Section Chapter 4.1 Mechanical connection.
30
Strength class of
screws
For screw clearance, see Chapter 3.1 Product drawing
; Secure the screws against unintentional loosening (e.g. use self-
3.5 Transport and storage conditions
Max. permitted
ambient temp. for
motor (transport/
storage)
Min. permitted
ambient temp. for
motor (transport/
storage)
With regard to cyclic speed loads, note that the rotating parts of
the device are designed for a maximum of one million load
cycles. If you have special questions, consult ebm-papst for
support.
8.8
locking screws).
+80 °C
-40 °C
Advertisement
Table of Contents
