Napoleon TQ285-1 Manual page 11

or orange flame or cause a fire (flashback) at the air shutter underneath the control panel. To clean the
inside of the burner, it must be removed from the gas grill: Remove the screw (s) that attach the cross
light bracket and the burner to the base. Slide the burner back and upwards to remove. Cleaning: Use
a flexible venturi tube brush to clean the inside of the burner. Shake any loose debris from the burner
through the gas inlet. Check the burner ports and valve orifices for blockages. Burner ports can close over
time due to cooking debris and corrosion; use an opened paperclip to clean them. The ports are easier to
clean if the burner is removed from the grill, but it can also be done with the burner installed.
CAUTION!
Ensure the insect screen is clean, tight, and free of any lint or other debris.
Reinstallation: Reverse the procedure to reinstall the burner. Check that the valve enters the burner when
installing. Replace cross light bracket and tighten screws to complete reinstallation.
WARNING!
!
the burner after cleaning it is very
important that the valve/orifice
enters the burner tube before lighting
your gas grill. If the valve is not inside
the burner tube a fire or explosion
could occur.
WARNING!
!
of these conditions exist, do not use the gas grill. Have the part replaced by your Napoleon Gas Grill
dealer or qualified gas installer.
N415-0535 Nov 02.20
Take care not to enlarge the holes.
When reinstalling
Hose (optional): Check for abrasions, melting, cuts, and cracks in the hose. If any
11
EN
www.napoleon.com