Panasonic KX-TGC410E Operating Instructions Manual page 41

General use
Problem
The handset does not turn
on even after installing
charged batteries.
The unit does not work.
The handset display is
blank.
I cannot hear a dial tone.
Menu list
Problem
The display is in a
language I cannot read.
I cannot activate the eco
mode.
I cannot register a handset
to a base unit.
I cannot remember the
PIN.
Helpline Tel. No.: U.K. 0344 844 3899 Ireland 01289 8333
TGC41x_42xE(en)_0229_ver011.pdf
Cause/solution
R Place the handset on the base unit or charger to turn on the
handset.
R Make sure the batteries are installed correctly (page 11).
R Fully charge the batteries (page 12).
R Check the connections (page 11).
R Unplug the base unit's AC adaptor to reset the unit and turn off
the handset. Reconnect the adaptor, turn on the handset and
try again.
R The handset has not been registered to the base unit. Register
the handset (page 44).
R The handset is not turned on. Turn the power on (page 15).
R Make sure that you are using the supplied telephone line cord.
Your old telephone line cord may have a different wiring
configuration.
R The base unit's AC adaptor or telephone line cord is not
connected. Check the connections.
R Disconnect the base unit from the telephone line and connect
the line to a known working telephone. If the working
telephone operates properly, contact our service personnel to
have the unit repaired. If the working telephone does not
operate properly, contact your phone service provider.
Cause/solution
R Change the display language (page 15).
R You cannot set eco mode when you set the repeater mode
"On". If required, set the repeater mode to "Off" (page 29).
R You entered the wrong PIN. If you forget your PIN, see "I
cannot remember the PIN." (page 41).
R Change the PIN using the following method.
1
MMENUN#132
2
*7000
3
Enter the new 4-digit base unit PIN. a MOKN
4
MbN: "Yes" a MOKN a MOFFN
41
Useful Information
2016/02/29 15:10:39
41