Tripp Lite B126-1P0-MINI Owner's Manual page 22

Extender/Splitter Daisy-Chain Installation
12
Connect the B126-1P0 or B126-1P0-MINI HDMI connector to a
monitor. Or, connect the B126-1P0-WP-1, B126-1A0 or
B126-1A0-WP-1 to a monitor using a Tripp Lite P568-Series HDMI
Cable. Both the green and orange RJ45 LEDs on the B126-1P0 and
B126-1P0-MINI, and the green LED on the B126-1P0-WP-1, illuminate
to indicate the unit is receiving power from the connected monitor.
13
Repeat step 12 for each additional monitor you are connecting.
14
Turn on the power to the HDMI source. The orange RJ45 LEDs illuminate
on the B126-004 to indicate the unit is receiving a signal from the
source. The screen should now be displayed on the connected monitors.
15
If necessary, use the Equalization control on the B126-1A0 or
B126-1A0-WP-1 to adjust the video image.
Note: An improper Equalization setting can cause the monitor not to display a
picture at all. Try each Equalization setting until an acceptable picture is displayed.
17-07-080-933023-EN.indd 22
22
(B126-004 only)
7/13/2017 10:54:14 AM