Tripp Lite B126-1P0-MINI Owner's Manual page 21

Extender/Splitter Daisy-Chain Installation
1
Make sure the HDMI source is powered OFF.
2
Connect the HDMI source to the INPUT port on the B126-004 using a
Tripp Lite P568-Series HDMI Cable.
3
Connect the LOCAL port on the B126-004 to the INPUT port on a
second B126-004 using the included 1 ft. HDMI daisy-chain cable.
4
Repeat step 3 if connecting a third B126-004.
5
Optional: Connect a local monitor to the LOCAL HDMI port of the last
B126-004 using a Tripp Lite P568-series HDMI cable.
6
Connect the external power supply to the first B126-004 in the
daisy-chain and plug it into a Tripp Lite Surge Protector, PDU or UPS.
The green RJ45 LEDs and the red Power LED on the B126-004 will
illuminate to indicate power is being received from the external power
supply.
7
Repeat step 6 for each additional B126-004 in the daisy chain.
8
Using Cat5e/6 cable, connect one of the RJ45 output ports on the local
unit to the RJ45 input port on a B126-1P0, B126-1P0-MINI,
B126-1A0, B126-1P0-WP-1 or B126-1A0-WP-1 remote unit.
9
Repeat step 8 for each additional remote unit being connected.
10
B126-1A0 and B126-1A0-WP-1 only: Connect the external power
supply to the B126-1A0 or B126-1A0-WP-1, and plug it into a
Tripp Lite Surge Protector, PDU or UPS. The green and orange LEDs
illuminate, with the green LED indicating the unit is receiving power
from the external power supply and the orange LED indicating the unit is
connected to a powered ON local unit via Cat5e/6 cable.
11
Repeat step 10 for each additional B126-1A0 or B126-1A0-WP-1 in the
installation.
17-07-080-933023-EN.indd 21
(B126-004 only)
21
7/13/2017 10:54:14 AM