Configuring The Me Firmware - Acer Aspire Z5760 Service Manual

Configuring the ME Firmware

You need to disable the Manageability Engine (ME) firmware before updating the BIOS. Use the
ME_DISABLE jumper to do this.
• 1-2 position: Normal operation (default)
• 2-3 position: ME disable
To disable the ME firmware:
1. Turn off the power to the computer and all peripherals.
2. Unplug the power cord from the computer.
3. Unplug the network cable and all connected peripheral devices from the computer.
4. Place the computer on a flat, steady surface with the rear cover facing upward.
5. Remove the computer stand, I/O cable cover, and rear cover by following the procedures described on
pages 26–28.
6. Remove the wall mount plate by following the procedure described on page 43.
7. Remove the graphics card by following the procedure described on page 44.
8. If necessary, remove any other assemblies or cables that prevent access to the ME_DISABLE jumper.
9. Locate the ME_DISABLE jumper on the mainboard.
10. Remove the jumper block and set it over the 2-3 pins for 20 to 30 seconds.
11. Return the jumper block to its default 1-2 position.
12. Reinstall the graphics card.
13. Reinstall any any other assemblies or cables that have previously been removed.
14. Reinstall the wall mount plate, rear cover, I/O cable cover, and the computer stand.
15. Connect the power cord to the system.
16. Press the power button
17. During POST, press Delete to access the Setup Utility.
18. Press F9 to load the system default values.
19. Press F10 to save the changes you made and close the Setup Utility.
Aspire Z3760 / Z3761 / Z5760 / Z5761 AIO Computer Service Guide
to turn on the computer.
87