Acer Aspire Z1620 Service Manual page 128

Playback is Choppy
If playback is choppy or jumps, perform the following:
1. Check that system resources are not running low:
 Close some applications.
 Reboot and try the operation again.
2. Check that the ODD controller transfer mode is set to DMA.
3. Navigate to Start
4. Double click IDE ATA/ATAPI controllers, then right click ATA Device 0.
5. Click Properties and select the Advanced Settings tab. Make sure the Enable DMA box
is checked and click OK.
6. Repeat for each ATA Device shown if applicable.
Drive Not Detected
®
If Windows cannot detect the drive, perform the following:
1. Start the computer and press F2 to enter the BIOS Utility.
2. Verify that the drive is detected in the ATAPI Model Name field on the Information page.
NOTE:
Verify that the entry is identical to one of the ODDs specified in Hardware Specifications
and Configurations.
 Remove power and remove the cover to inspect the connections to the ODD. Refer to
Maintenance
 Check for broken connectors on the drive, motherboard, and cables.
 Check for bent or broken pins on the drive, motherboard, and cable connections.
 Try an alternate cable, if available. If the drive works with the new cable, the original
cable should be replaced.
3. Reseat the drive, making sure and all cables are connected correctly.
4. Replace the ODD. Refer to
Drive Read Failure
If discs cannot be read when inserted in the drive, perform the following.
1. Remove and clean the failed disc.
2. Retry reading the CD or DVD.
 Test the drive using other discs.
 Play a DVD movie
 Listen to a music CD
118
 
Control Panel System and Maintenance
Flowchart.
Maintenance Flowchart.
 
System Device Manager.