Set Internal Calibration Password (Fnc-16) - Excell 120S User Manual

EXCELL PRECISION CO., LTD
Item Function
FNC-13 Turn-on zero setting
FNC-14 Stand-by mode setting
Zero function record
FNC-15
Internal calibration
FNC-16
password setting
FNC-17 Turn on/off watchdog

2-4 Set internal calibration password (FNC-16)

The default value of FNC-16 is 0000, which means internal calibration without password. To
set a password, enter 4-digit numbers (other than 0001, 0000) and press confirm key to
complete. If password is set to 0001, error message "UN.VALI" will appear.
If password has been set, FNC-16 will display 0001. To change password, it must enter
the previously set password first. If entered password is wrong, it displays "PW ERR". If entered
password is correct, it displays "NEW PW" and then enters 4-digit numbers (other than 0001) for
new password or enters 0000 to remove password. If password is forgotten, it must reset to
factory setting.
040112XX
Parameter
setting
0000
0001
Setting value
Description
0 Disable
1 Enable
Disable all the functions under
0
stand-by mode
Only turn off display but not
1 disable other functions under
stand-by mode
Zero point record not saved into
0
EEPROM
Zero point record saved into
1
EEPROM
No password
Password is set
1 Turn on watchdog
0 Turn off watchdog
13
Default
0
0
0
0000
1
ZSME400000004