Vertiqual Engineering CONEX 12 Instruction Manual

Edition: 02.02.2021
EN
Instruction manual for connecting lanyards
certified according to EN 354:2010
CONEX 12 CONEX 14 SCOPE (RED / WHITE)
Twisted rope Ø16mm
Kernmantle rope Ø12mm Kernmantle rope Ø14mm
Thank you for choosing VERTIQUAL®! You have purchased a high quality product that will reliably protect you and will be your companion for a long time when
working at heights and depths. This manual must be read and understood before using the product! This product will be used with other equipment (components) thus
forming a system for working at heights. Please refer to the instruction manual of each component in your system for compatibility and correct use! Following these in-
structions accordingly is essential for your safety. Failure to do so can result in serious or even fatal accidents! Keep these instructions together with the product, accessi-
ble to all users, so they can consult them whenever is needed!
Warning! These instructions are a basic comprehensive guide to the safe use of the purchased equipment. They contain general information about the product, in-
tended to help the user, but cannot cover all the situations that may occur in the daily activities and cannot in any case replace the specialized training courses for safety
at heights. This PPE against falls from heights can only be used by well-trained users, who are familiar with the relevant legislation and who have successfully completed
a special safety training course for working at heights.
WARNING! For works with risk of falling from heights or in depths, a risk assessment must be carried out in advance in accordance with current regulations and legal
provisions (EN standards or specific national rules) that will provide adequate measures for safety and rescue!
WARNING! Instructions for use are updated when technical or legislative changes occur. The latest version of the instructions overwrites previous versions and is the
only valid version. Please make sure you follow the instructions of the most recent version. You can download the most recent instructions from our website
www.vertiqualsafety.com by accessing the section of each product. For help or additional questions, please contact us at office@vertiqualsafety.com or Tel. (+40)
0365/882143.
WARNING! The user must be medically fit and capable to ensure his own safety and act accordingly in possible emergency situations! Seek medical approval according
to the national legislation in force!
WARNING! If the product is re-sold outside the original country of destination, the reseller must provide these instructions manual in the language of the country where
the product will be used.

DESCRIPTION

The CONEX / SCOPE connecting lanyards are made of high tensile polyamide ropes with sewn / spliced terminations and protective thimbles. The CONEX type can be
manufactured from Ø12mm or Ø14mm kernmantle ropes and SCOPE is manufactured from Ø16mm twisted rope. The lanyards can be supplied without connectors or
can be equipped with EN 362 certified connectors!

FIELD OF USE

Connecting lanyards belong to the category of personal protective equipment (PPEaF) and are intended to protect the user while working at heights or in depths. These
products must be used in usual environments with temperatures between -30°C and +50°C, without potentially explosive atmospheres, far away from flames, sparks or
hot metal splash. Avoid contact with sharp edges, electricity, chemicals, corrosive solutions and substances, excessive heat, oils, paints or any other contaminants. The
structures used for anchoring have to meet the requirements of EN 795-2012, must have NO sharp or abrasive edges, must be capable to withstand minimum 12kN and
must NOT allow accidental slippage or disconnection of the lanyard or carabiner.