Citizen 6S10 Manual page 10

B) SETTING THE DATE
1. Pull the crown out to the 1st Click Position.
2. Turn the crown clockwise to set the date.
* If the date is set between the hours of around 9:00 PM and 1:00 AM, the date may not change on
the following day.
3. After the date has been set, push the crown back to the Normal position.
C) USING THE CHRONOGRAPH
This chronograph is able to measure and display time in 1/20 second united up to maximum of 59min
59sec. The chronograph 1/20 second hand keeps continuously for 30 seconds after starting, and then
stops at Zero position.
【 【 【 【 Measuring time with the stopwatch】 】 】 】
1. Press button " A " to start the chronograph.
2. The chronograph can be started and stopped each time button "A" is pressed.
3. Press button "B" to reset the chronograph and chronograph minute and second hands return to their
Zero positions.
Reset
D) CHRONOGRAPH RESET (INCL. AFTER REPLACING BATTERY)
This procedure shoud be performed when the chronograph second hand does not return to the Zero
position.
1. Pull the crown out to the 2nd Click Position.
2. Press the button "A" once to set the chronograph second hand to the Zero position.
3. Press the button "B" once to set the chronograph 1/20 second hand to the Zero position.
* The chronograph hands can be advanced rapidly by continuously pressing button "A" or "B".
4. Once the hands are set at Zero position, reset the time and return the crown to its normal position.
These specifications might be changed without prior notice.
Time
"A"
Measurement
"A"
Stop
"A"
"B"