nvent CTS04 Instruction Sheet
nvent CTS04 Instruction Sheet

nvent CTS04 Instruction Sheet

Telescoping pipe stand

Advertisement

INSTRUCTION SHEET
CTS04, CTS10
Telescoping Pipe Stand
1-4" Pipe

WARNING:

1.
nVent products shall be installed and used only as indicated in nVent product instruction sheets and training materials. Instruction sheets are available at
www.nVent.com and from your nVent customer service representative.
2.
nVent products must never be used for a purpose other than the purpose for which they were designed or in a manner that exceeds specified load ratings.
3.
All instructions must be completely followed to ensure proper and safe installation and performance.
4.
Improper installation, misuse, misapplication or other failure to completely follow nVent's instructions and warnings may cause product malfunction, property
damage, serious bodily injury and/or death, and void your warranty.
5.
Products that are manufactured using spring steel components shall be used only in a non-corrosive indoor environment.
6.
All pipe supports, hangers, intermediate components and structural attachments must ONLY be used as described herein and are NEVER to be used for any
other purpose.
NOTE: All load ratings are for static conditions and do not account for dynamic loading such as wind, water or seismic loads, unless otherwise noted.
The customer is responsible for:
a. Conformance to all governing codes.
b. The integrity of structures to which the products are attached, including their capability of safely accepting the loads imposed, as evaluated by a qualified
engineer.
c. Using appropriate industry standard hardware as noted above.

SAFETY INSTRUCTIONS:

All governing codes and regulations and those required by the job site must be observed.
Always use appropriate safety equipment such as eye protection, hard hat, and gloves as appropriate to the application.
nVent, nVent CADDY, nVent ERICO Cadweld, nVent ERICO Critec, nVent ERICO, nVent ERIFLEX, and nVent LENTON are
owned by nVent or its global affiliates. All other trademarks are the property of their respective owners. nVent reserves the
right to change specifications without prior notice.
TECHNICAL SUPPORT:
www.nVent.com
Part Number
Article Number
CTS04
580065
CTS10
580066
*Factor of Safety: 3.5:1
CFS565_C
1 OF 2
Pipe Sizes in (mm)
*Static Load Ratings lbs (N)
1-4 (25-100)
5-10 (125-250)
5-10" Pipe
© 2017-2019 nVent All Rights Reserved
1,370 (6,094)
1,740 (7,740)

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CTS04 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for nvent CTS04

  • Page 1 All instructions must be completely followed to ensure proper and safe installation and performance.
  • Page 2 CADDY, nVent ERICO Cadweld, nVent ERICO Critec, nVent ERICO, nVent ERIFLEX, and nVent LENTON are owned by nVent or its global affiliates. All other trademarks are the property of their respective owners. nVent reserves the right to change specifications without prior notice.

This manual is also suitable for:

Cts10580066580065

Table of Contents