Dual Head - Universal Laser Systems X-660 Safety, Installation, Operation, And Basic Maintenance Manual

Removal, Cleaning, and Replacement of the Filter
•
Turn the Air Compressor OFF and unplug it.
•
Unscrew the cover by turning it 1/8 turn counterclockwise
like you were unscrewing a jar, and pull down. The clear
plastic container might still remain attached to the top.
Gently pull this part straight down.
•
You will see a red colored foam filter. Unscrew the filter,
and wash it out with water. Make sure that it is completely
dry, then reinstall.
•
Empty and clean out any residue or dust that may have
accumulated on the bottom of the clear plastic container.
•
Install the clear plastic container into the cover and line up
the tabs so that they fit one inside of the other.
•
Insert the combination of the cover and the clear plastic
container into the top of the assembly. Gently twist the
cover 1/8 turn clockwise to lock it into place.
Removal, Cleaning, and Replacement of the Desiccant
•
Turn the Air Compressor OFF and unplug it.
•
Pull down on black lever and rotate metal cover 1/8
turn counterclockwise. Remove metal cover by pulling
straight down.
•
With a gentle and slight twisting motion, pull the clear
container downward slowly. Pour out and discard old
desiccant.
•
Refill clear container with fresh desiccant from a
sealed bag. Fill to about ¼ inch from top of container.
•
Clean off rubber o-ring on the top of the container.
•
Insert container up into the top.
•
Install metal cover and turn 1/8 turn until lever clicks into place.

Dual Head

The Dual Head option was created to enhance productivity when engraving large quantities of the same
item providing that two or more of the same item fit within the horizontal engraving area (X-axis) of your
laser system. The Dual Head option can significantly reduce your overall engraving time if you divide the
total processing time by the quantity of items engraved, however, there are limitations involved when
using this option.
•
It is not "twice as fast" than engraving with a single head. Typical productivity increases may vary
from 25-75%
•
In some applications, using the Dual Head option may reduce efficiency than engraving with a single
head.
•
There is an overall laser power loss due to additional optics ranging from 1% - 5%.
•
The beam is not split EXACTLY 50/50 although it is close enough for most applications.
•
Because of optical angles and the effect of passing the beam through splitting optics, the engraving
field most likely WILL NOT be split EXACTLY in half. There may be a small tolerance in absolute
beam positioning by as much as +/- 1/16
the difference by adjusting the spacing between your objects in the engraving area.
ACCESSORIES
th
of an inch. In this case, you would need to compensate for
Section 6-8