DeWalt DXAM-2250 Original Instructions Manual page 10

English
SAVE THESE INSTRUCTIONS
OPERATING INSTRUCTIONS
WARNING!
TO REDUCE THE RISK OF FIRE OR ELECTRIC
SHOCK,DO NOT USE THIS AIR MOVER WITH ANY
SOLID-STATE SPEED CONTROL DEVICE.
Follow these instructions to operate your air mover:
• Unpack air mover from carton.
To use your unit, place the unit in the area most
•
suitable for your application. Several factors need
to be considered; the unit must be placed close
enough to an AC outlet to be plugged in, there
must be a minimum clearance of two feet from
either side of the unit to allow for proper air ow,
and the unit should not be placed where it can
become a tripping or safety hazard.
•
Place unit in the proper operating position for your
application. Refer to the Operating Positions
section in this manual.
•
Plug unit into the wall.
• Turn unit on and select air speed by turning the
switch, located near the top handle, clockwise.
•
When your drying job is completed, turn the unit
off and follow the directions for Storage in this
manual.
CAUTION: After you plug the power cord into
the wall receptacle, turn the unit "ON" by pushing
the switch position with 3 embossing straps is the
"ON"position.
Air Mover Position Operating
The air mover may be set in one of three
operating positions. Pick the position best suited
for your application.
• Use the down position (Figure 2) for applications
such as; drying wet oors, shampooed carpets, etc.
To use this position simply place unit on its base.
•
Use the angle position (Figure 3) for applications
such as, drying plaster on walls or drying wet
furniture. To use this position, tilt unit backwards so
it rests on the support.
•
Use the up position for applications such as; drying
paint on the ceiling. To use this position, lay the unit
on the back side with the front grill pointing towards
the ceiling (Figure 4).
STORAGE
• Before storing your air mover it should be cleaned.
• Wrap the power cord around the carry handle on
the top of the unit to keep it untangled (Figure 5).
THE AIR MOVER SHOULD BE STORED INDOORS.
TROUBLESHOOTING
WARNING: Unplug before any
disassembly or servicing.
WARNING: All disassembly and repairs
should be performed by qualified
personnel.
NOTICE:Reset circut protector
Minor problems often can be xed without calling
customer service.
8