Lenovo ideacentre 510 Series Hardware Maintenance Manual page 45

Step 10. Position the new memory module over the memory slot. Ensure that the notch
module aligns correctly with the slot key
until snaps into position.
Step 11. To replace a UDIMM memory module, refer to the following instructions:
Step 12. Remove the memory module being replaced by opening the retaining clips as shown.
Step 13. Position the new memory module over the memory connector. Make sure the notch
memory module is correctly aligned with the connector key
memory module straight down into the connector until the retaining clips close.
1 in the memory slot. Press the memory module down
2 on the system board. Push the
2 on the memory
1 on the
.
Chapter 8 Replacing hardware
39