Table of Contents
Advertisement
Filling the refresher tank
If you select a steam programme,
Note:
you must fill the refresher tank with
distilled water.
Select the steam programme you
1.
require. ~ "Overview of
programmes" on page 22
Set the required steam programme.
2.
ì will appear on the display.
3.
If ì does not appear on the
Note:
display, the refresher tank is already
filled with the correct amount of
water. Touch Start/Pause A to start
the steam programme.
Pull out the condensation container
4.
horizontally.
Pour distilled water into the filling
5.
hole on the refresher tank using the
jug provided until ì goes out on the
display.
Make sure that you pour the distilled
water into the correct filling hole.
Caution!
The appliance may be
contaminated with fluff or be
damaged by deposits.
Fill the refresher tank with distilled
water only. Do not use condensation
water or additives.
The refresher uses
Note:
approximately 450 ml of distilled
water during the drying cycle. If you
have poured more than 700 ml of
distilled water into the filling hole and
ì does not go out on the display,
either you have poured the distilled
water into the wrong filling hole or
the appliance is not level. Pour the
distilled water into the correct filling
hole or make the appliance level.
Push the condensation container
6.
back into the appliance until you feel
it lock into place.
Press Start/Pause A.
7.
Refresher
en
33
Advertisement
Table of Contents
