Filling The Refresher Tank; Starting The Programme; Programme Sequence; Changing The Programme Or Adding Laundry - Bosch WTW85530BY Installation And Operating Instructions Manual

Filling the refresher tank

If you select a steam programme,
Note:
you must fill the refresher tank with
distilled water.
Select the required steam
1.
programme from the Programmes
section ~ Page 13.
Use the programme selector to set
2.
the required programme.
ò appears in the display panel.
3.
If ò does not appear in the
Note:
display panel, the refresher tank is
already filled and does not need to
be refilled. Press the Start button.
Pull out the condensate container.
4.
Pour distilled water into the filling
5.
hole on the refresher tank using the
jug provided until ò goes out on the
display panel.
Caution!
The dryer may be contaminated
with fluff or be damaged by
deposits.
Only fill the refresher tank with
distilled water; do not use
condensation or additives.
Push in the condensate container
6.
until you feel it lock into place.
Press the "Start" button.
7.
Notes
If you want to interrupt the
■
programme (to add laundry, for
example), open the dryer door and
then press the Start button to
continue.
With the recommended load, the
■
steam programmes use approx. 250
- 300 ml of distilled water.
Operating the appliance

Starting the programme

Press the Start button.
If you want to lock the
Note:
programme to prevent it from being
inadvertently adjusted, you can select
the childproof lock, see ~ Page 15.

Programme sequence

The programme status is displayed in
the display field.
Changing the programme or
adding laundry
:
Warning
Risk of scalding!
If you have selected a steam
programme, hot steam may escape.
You may scald yourself. Open the dryer
door carefully.
You can remove or add laundry and
change or alter the programme at any
time during drying.
To pause the programme, open the
1.
dryer door or press the Start button.
Add or remove laundry.
2.
Select another programme or an
3.
additional function, if required.
Close the dryer door.
4.
Press the Start button.
5.
The programme duration in the
Note:
display panel is updated depending on
the load and residual moisture in the
laundry. The values displayed may
change after the programme is
changed or the load is adapted.
en
17