Advertisement
Package Contents
• B110-SP-HDMI In-Line Surge Protector
• Grounding Wire, 12 in.
• Mounting Screws (x2)
Product Features
• Protects an HDMI input and output
against Electrostatic Discharge (ESD),
lightning surges and cable discharge
events
• Meets IEC regulations:
o IEC 61000-4-2 (ESD) +/- 15kV(air),
+/- 8kV(contact)
o IEC 61000-4-4 (EFT) 40A (5/50ns)
o IEC 61000-4-5 (Lightning) 5A
(8/20µs)
Installation
Note: The following instructions assume that two HDMI devices are currently connected together.
Single Device Protection:
1. Disconnect the installed HDMI cable from the device you wish to protect and attach
this cable to the "Cable End" of the In-Line HDMI Surge Protector.
2. With a user-supplied HDMI cable, connect the device to be protected to the
"Equipment End' of the In-Line HDMI Surge Protector.
Note: For maximum protection, the HDMI cable between the "Equipment End" of the In-Line
HDMI Surge Protector and the HDMI equipment to be protected should not exceed 3 ft.
(0.9 m). Tripp Lite P568-003-Series High-Speed HDMI cables are recommended.
3. Connect the ground wire to either end of the In-Line HDMI Surge Protector and then
to earth ground.
HDMI Monitor
(Protected)
19-03-094-93384D-EN.indd 2
In-Line HDMI
Surge Protector
Equipment
Cable
End
• Screw Anchors (x2)
• Grounding Wire Screw
• Quick Start Guide
• Lightning
Protection
• Solid-state silicon-avalanche technology
• Low TMDS loss
• Supports UHD resolutions up to 4K x 2K
@ 30 Hz
• HDMI 1.4 and HDCP-compliant
• Easy in-line installation with integrated
mounting ears
• Passive by design – no external power
required
End
2
reaction speed: < 1ns
HDMI Player
(Not Protected)
5/17/2019 1:01:10 PM
Advertisement
