Led Control; Control Panel - Caesar Fireplace CHFP-002 Installation And Operating Instructions Manual

F. T o change brightness, press the DIMMER
will show "L1" to "L5" when pressing this button.
G . To change flame speed, press the SPEED
show V1 to V5 when pressing this button. " " "
H-1 . Under the unlock mode
set for low heat (750W)
indicator will show
the
the indicator will show OF
H-2 . Under the unlock mode
will be set for low heat (750W)
indicator will show
the
the indicator will show
I. Press "TIMER"
ranges from 1 to 8 hours, which will be shown on the indicator from "1H" to "8H". Timer is turned off when the
indicator shows "0H". If the appliance is restarted, timer also needs to be reset again.
button to set room temperature Press + to heat up, press - to cool down. (It is inapplicable to
J. Press
SCW series)
K. Press the "ON/OFF"
NOTE: This remote control must remain within 8 meters or 26 feet of the appliance to be
effective and this range may be reduced as the battery power is depleted.

7.3 LED CONTROL

NOTE: It is applicable to CHFP-30B, CHFP-40B, CHFP-50B, CHFP-60B, CHFP-74B, CHFP-74BS,
and CHFP-102B.
A. The button can be used to power up or down the backlight.
B. To change backlight, press the
cyan, and purple.
C. To change brightness, press the

7.4 CONTROL PANEL

NOTE: Control panel is the same as remote control.
"
"
"
, to activate the heater press the HEAT
, the indicator will show
"--". Press it for the third time, then the mechanism will stop function. After 10 seconds,
" ". (For CHFP- ××B, CHFP-74BS, SCI-001, SCI-002, SCW, and CHFPN series)
, to activate the infrared heater press the HEAT
, the indicator will show
"--". Press it for the third time, then the mechanism will stop function. After 10 seconds,
"O ". (For CHFP-002 and SCI-003) F
button, this sets the timing for switching the fireplace off automatically. The timer
button to turn off the appliance.
button. There are 7 colors to choose from, yellow, red, blue, white, green,
button. There are 5 adjustments to choose from.
" button. There are 5 adjustments to choose from. The indicator
" button. There are 5 speeds to choose from.
, " "
"-". To adjust the heat level press again for high heat 1500W)
, "
"-". To adjust the heat level press again for high heat 1500W)
.
The indicator will
button. The initial set-up heat level will be
" button. The initial set-up heat level
(
,
(
,
20