Cleaning Side Brushes - Shark IQ Self-Empty Instructions Manual

MAINTENANCE
SHARK ANTI HAIR WRAP TECHNOLOGY®
The Anti Hair wrap Brush-roll removes debris over time as it cleans. If some debris
remains wrapped around the brush-roll, continue cleaning to allow the brush-roll to
remove it.
If some debris remains on the brush-roll after continued cleaning, follow the steps below
to remove it.
To access the brush-roll, push up on the tabs on the
brush-roll access door, then lift off the door.
NOTE: When cutting away debris, be sure not to cut the brush-roll.
NOTE: Replace brush-roll every 6 to 12 months, or when visibly worn. See sharkclean.eu for replacement parts.
s h a r kc l e a n . e u
Lift out the brush-roll, and clean off any debris.
Reinstall the brush-roll, inserting the flat end first.
Close the brush-roll access door and press down
until both sides click into place.
MAINTENANCE
CLEANING SENSORS AND CHARGING PADS
CLEAN SENSORS AND CHARGING PADS AS NEEDED. With a dry cloth, gently dust off the sensors and
pads located on the bottom of the robot and on the base.
IMPORTANT: The robot uses cliff sensors to avoid stairs and other steep drops. Sensors may work less effectively when
they are dirty. For best results, clean sensors regularly.

CLEANING SIDE BRUSHES

CLEAN SIDE BRUSHES AS NEEDED.
NOTE: Remove and replace any side brushes that are bent or damaged. To remove a brush, lift it off its peg.
NOTE: Cloth not included.
Carefully unwind and remove any string or hair
wrapped around brushes.
Gently wipe brushes with a dry cloth. To reinstall,
snap the brushes over the pegs. Spin the brushes
manually to make sure they are installed correctly.
s h a r kc l e a n . e u