Table of Contents
Advertisement
Dugan Model E-2A User Guide
6. Wait 60 seconds and if the list pane is blank, click Refresh List.
If the list pane remains blank, proceed to Manually Add Unit below.
If the list pane displays Dugan units, continue.
7. Click on the first unit in the list so it is highlighted.
The Network Parameters section displays information about that unit.
If you see Unit Reachable: YES, you are ready to use the Dugan Control Panel with
that unit. If you have additional Dugan units to connect, select the next unit in
the list and repeat this step. If you are finished with installation, proceed to
Chapter 6: Dugan Control Panel Software.
If you see Unit Reachable: NO, proceed to the next step.
8. De-select the Use DHCP parameter.
9. Match the first three groups of the IP Address with the computer, and assign
your own number to the last group.
10. Click Send New Params to Unit.
The Model E-2A will reboot.
11. Click Refresh List.
12. Highlight the unit in the list pane again.
If you see Unit Reachable: YES, this unit is ready to use with the Dugan Control Panel.
If you have additional Dugan units to connect, select the next unit in the list and
repeat Step 7. If you are finished with installation, proceed to Chapter 6: Dugan
Control Panel Software.
Figure 5-4 Dugan Utility
31
Connecting to a Computer
Advertisement
Table of Contents
