Table of Contents
Advertisement
QUICK START GUIDE (PROPANE)
1.
The shipping braces prevent engine movement during
shipment. Flip the generator over and remove the brightly
colored brace between the motor and the frame, and the
wood brace under the generator.
2.
The oil fill cap is located on the lower engine block to the
right of the recoil start housing. Remove the oil fill cap and
fill with 10w30 oil.
3.
The breaker is located on the right side of the front power
panel. Flip the breaker down to prevent accidental load
when starting the generator.
4.
The gas valve is located above the recoil start on the
bottom of the fuel tank. Rotate the valve counter clockwise
to the horizontal position to stop the flow of gasoline to
the carburetor.
5.
The propane regulator / decompression valve is located
on the frame of the generator below the OHV valve cover.
Ensure the propane hose is securely connected to the
regulator/compression valve.
12
Remove shipping braces
Add oil
Turn breaker off
Turn gas valve off
Connect propane hose
6.
Connect propane tank
The propane hose is located on the left side of the regulator,
below the OHV valve cover. Screw the open ACME nut
connection to your propane tank and turn the tank on.
7.
Adjust choke
The choke lever is located above the air filter to the right
of the recoil start. Slide the lever to the right to open the
choke and increase air into the carburetor for normal
running.
8.
Start
The key switch is located on the left side of the front power
panel. Insert the key and turn to the start position to start
the generator. Allow the key to return to the run position
once started.
9.
Turn breaker on / connect
The breaker is located on the right side of the front power
panel. Flip the breaker up to allow power to flow to the
receptacles. Connect your devices to the receptacles on
the front panel. Start with the largest loads first.
13
Advertisement
Table of Contents
