Connection To Power Mains - Lindab AGHR-100 User Manual

DISCONNECT THE VENTILATOR FROM POWER MAINS PRIOR TO ANY ELECTRIC INSTALLATION OPERATIONS.
CONNECTION TO POWER MAINS SHALL ONLY BE PERFORMED BY A PROFESSIONAL ELECTRICIAN QUALIFIED FOR
UNASSISTED OPERATIONS WITH ELECTRICAL INSTALLATIONS UP TO 1000 V AFTER CAREFUL STUDY OF THE PRESENT
USER'S MANUAL.
THE RATED ELECTRICAL PARAMETERS ARE STATED ON THE RATING PLATE. ANY TAMPERING WITH THE INTERNAL
CONNECTIONS IS PROHIBITED AND WILL VOID THE WARRANTY.
The ventilator is rated for connection to single-phase ac 1~100-230 V / 50-60 Hz power main using a pre-wire pre-wired power cord and a plug.
Connect the ventilator to power mains through the automatic circuit breaker with magnetic trip integrated into the fixed wiring system.
VENTILATOR WIRING DIAGRAM
The jumper between the contacts 1 and 2 or 2 and 3 of CN7 socket
connector determines a flow direction in Ventilation mode.
If the jumper connects the contacts 1 and 2, air is extracted from
the room in Ventilation mode (factory setting).
If the jumper connects the contacts 2 and 3, air is supplied in
Ventilation mode.
ASHR-100

CONNECTION TO POWER MAINS

XS4
XS2 XS1
A1
Ventilator controller
1~100-230 V
XS3
50-60 Hz
TB3
L
1
2
3
TB1
L
G
D
+
N
TB2
L
CN7
G
1 4
D
2 5
+
3 6
N
17